DIR Return Create A Forum - Home
       ---------------------------------------------------------
       intcorecycling
  HTML https://styrofoamrecycling.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: General Discussion
       *****************************************************
       #Post#: 39--------------------------------------------------
       Waste Polystyrene Foam Fish Box Recycling Process
       By: INTCOrecycling Date: April 18, 2018, 8:15 pm
       ---------------------------------------------------------
       Defoaming the polystyrene pellets, usually using mechanical
       recovery method will waste polystyrene foam block to heat the
       volume and embrittlement, and then into the crusher into small
       pieces, after the extruder melt, exhaust, extrusion granulation.
       For polystyrene foam sheets, some are fed directly into
       specially designed recyclers, which typically have a large feed
       inlet to allow large plates to be fed directly with a rotating
       cutter, can be softer polystyrene foam plate chopped and heated,
       so that the melt and then squeeze a certain density of the
       material. And some are directly connected with the exhaust
       extruder, direct extrusion granulation, polystyrene to obtain
       pellets.
       First remove the dirt from the waste polystyrene foam into the
       Styrofoam recycling machine, broken into 60mmX60mm pieces,
       through the wind sorting machine to remove heavy foreign body,
       from the pipeline to the separator to further remove impurities,
       leaving only The lower polystyrene foam fragments are blown into
       the circular silo from compressed air.
       And then the mass of the foam block to the next process of the
       washing machine, waste polystyrene foam block in the washing
       machine with water spray cleaning and centrifugal dehydration,
       and then dried by air, into the crusher crushed into about 20mm
       pieces and After drying by hot air to further reduce the water,
       still by the pipeline into the middle storage tank for the use
       of the following extruder.
       Extruder with two exhaust holes, waste polystyrene foam block in
       the extruder in the gradual heating and melting, with the
       rotation of the screw produced by the shear, so that the bubble
       burst, the gas discharged from the exhaust hole. Finally, from
       the die extrusion of the dense material, the granulation
       cooling, to obtain better quality polystyrene recovery of
       pellets.
  HTML http://www.intcorecycling.com/GREENMAX-EPS-Styrofoam-Recycling-Machines.html
       *****************************************************