gopher.createaforum.com/1/forums/ollr/p/9574

   DIR Return Create A Forum - Home
       ---------------------------------------------------------
       Old Leafsprung Land Rovers
  HTML https://ollr.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: Technical tips &amp; Questions
       *****************************************************
       #Post#: 100366--------------------------------------------------
       door skins 
       By: Gozo_Joseph Date: January 5, 2016, 11:35 am
       ---------------------------------------------------------
       hello
       so.. now that the bulkhead is down galvanizing alley... hoping
       it will turn out ok... (finally)
       i have directed my attention to the doors. i was wondering if i
       should try ask the local sheet metal guy to do them for me (me
       helping him out using the old ones as templates) using 1mm or
       thinner zing?? since i'd like to dip the door frames as well.
       new ones are leaving the factory floor that way anyway...
       comments?? britpart skins are at about 20s a piece??? the metal
       guy is good and has good bending skills
       thanks ...
       joe (the one from malta)
       #Post#: 100374--------------------------------------------------
       Re: door skins 
       By: ashcrroft752 Date: January 5, 2016, 1:55 pm
       ---------------------------------------------------------
       If the local chaps skills are good I'd use him.
       *****************************************************