DIR Return Create A Forum - Home
---------------------------------------------------------
Old Leafsprung Land Rovers
HTML https://ollr.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Technical tips & Questions
*****************************************************
#Post#: 90433--------------------------------------------------
Exhaust Pipe Bending.
DIR By: wavey
Date: July 7, 2014, 1:37 pm
---------------------------------------------------------
Just wondering if anyone has any ideas on how to bend 2" exhaust
pipe without spending a fortune on a pipe bender..
I need to make a specific A bar type concoction (its original
for the motor not being :gay:) for pheebs. Local exhaust place
want silly money to do 2 90 degree bends!
Ideas folks?
#Post#: 90434--------------------------------------------------
Re: Exhaust Pipe Bending.
DIR By: wavey
Date: July 7, 2014, 2:01 pm
---------------------------------------------------------
HTML https://scontent-b-lhr.xx.fbcdn.net/hphotos-xfa1/t1.0-9/28303_10150167188250317_1487738_n.jpg
It's not :gay: honest guv.. :executioner:
#Post#: 90440--------------------------------------------------
Re: Exhaust Pipe Bending.
DIR By: samc88
Date: July 7, 2014, 3:59 pm
---------------------------------------------------------
Tis a bit ;D
If you heat it up you might be able to knock it round a bit of
bar to make a bend, wont be as easy as a bender though. Where
are you?
#Post#: 90446--------------------------------------------------
Re: Exhaust Pipe Bending.
DIR By: espacekiller
Date: July 7, 2014, 7:15 pm
---------------------------------------------------------
buy them pre bent off ebay?
#Post#: 90452--------------------------------------------------
Re: Exhaust Pipe Bending.
DIR By: rangerovering
Date: July 8, 2014, 3:04 am
---------------------------------------------------------
^^wot mr killer said. Can then weld on the straight bits to make
the size you want
#Post#: 90474--------------------------------------------------
Re: Exhaust Pipe Bending.
DIR By: samc88
Date: July 8, 2014, 12:32 pm
---------------------------------------------------------
I forgot you could get 90 degree bits :banghead
in which case yes do as the above say! If you were local to me
in the Anglesey North Wales area (Im in holyhead, I could have
got a bit bent up in work
#Post#: 90475--------------------------------------------------
Re: Exhaust Pipe Bending.
DIR By: wavey
Date: July 8, 2014, 12:50 pm
---------------------------------------------------------
Ive actually found a geezer on ebay that will make them custom
for about 50quid.. by the time I piss about I might aswell have
it don't pukka.
Cheers
*****************************************************
Page 1 of 1