DIR Return Create A Forum - Home
---------------------------------------------------------
MT Owners Club
HTML https://mtowners.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: MT-01
*****************************************************
#Post#: 517--------------------------------------------------
New MT01 Forum
DIR By: rickblue21
Date: October 1, 2018, 11:20 pm
---------------------------------------------------------
Hi guy's, been off the site a while and came back for a look and
found this new forum. Not sure what happened to the old site
closing but there was a wealth of information that maybe has
gone forever, I hope not. Also good to see some of the old names
from the previous forum. Good luck all and hope we grow from
strength to strength :) Rick .
#Post#: 518--------------------------------------------------
Re: New MT01 Forum
DIR By: gorilla
Date: October 2, 2018, 12:43 pm
---------------------------------------------------------
Who made the pipes.
Thanks Derek
#Post#: 533--------------------------------------------------
Re: New MT01 Forum
DIR By: Vishnuisgod
Date: October 23, 2018, 5:21 pm
---------------------------------------------------------
--- Quote from: gorilla link ---
>
> Who made the pipes.
> Thanks Derek
>
--- End Quote ---
ya, who makes em!?!?!?!
#Post#: 534--------------------------------------------------
Re: New MT01 Forum
DIR By: mt01ash
Date: October 23, 2018, 11:52 pm
---------------------------------------------------------
--- Quote from: Vishnuisgod link ---
>
> [quote author=gorilla link=topic=86.msg518#msg518
date=1538502238]
> Who made the pipes.
> Thanks Derek
>
--- End Quote ---
ya, who makes em!?!?!?!
[/quote]
They look like Oval Racing from Australia not 100% but sure look
like them
#Post#: 554--------------------------------------------------
Re: New MT01 Forum
DIR By: MDS
Date: November 15, 2018, 1:00 am
---------------------------------------------------------
Hello, just joined the forum with a new post but copying here
too looking for advice!
I own a clean 12000 mile 07 MT01 which has developed a starter
issue...
I recently heard a mild clonk when cranking - which immediately
left the starter motor freewheeling when hitting the start
button.
From the high pitched spinning starter response it appeared that
the starter one way clutch might have failed.
I removed the engine case to begin the strip but found a rather
confusing situation....The manual states that the starter clutch
should freewheel clockwise when viewed head on and lock (to turn
crankshaft) when driven anticlockwise.
This is the case on my bike so the starter clutch is not at
fault - however the starter motor is spinning the clutch in the
freewheel clockwise direction!
Everything seems to be in order mechanically, except the starter
seems to be turning the wrong way!
Can anyone tell me if my starter pinion anti clockwise direction
is correct? Really can't see how this could occur but I cant see
any other solution other than to reverse the starter rotational
direction. My starter pinion turns anticlockwise, this then
turns through the connection gears resulting in a freewheel slip
of the starter clutch gear clockwise.....The clutch needs to be
driven the other way to lock and drive the crank! Bizarre.
#Post#: 884--------------------------------------------------
Re: New MT01 Forum
DIR By: rickblue21
Date: October 8, 2019, 8:13 pm
---------------------------------------------------------
I made the pipes, stainless steel, they go a nice colour over
time. I made the handlebar risers plus other mods including all
the rear subframe bits, seat etc
Rick
*****************************************************
Page 1 of 1