DIR Return Create A Forum - Home
---------------------------------------------------------
Lynx Wind Forum
HTML https://lynxwindforumhtml.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Wind Power
*****************************************************
#Post#: 5079--------------------------------------------------
started a new stator
By: killer Date: January 8, 2015, 9:53 pm
---------------------------------------------------------
made a new coil it is 3/8 thick and 3 1/2 round with 17 awg wire
at 90 turns. test at 450 rpm it has 5 volt. dead short on meter
it is reading 6.5 amps. ok. if i make a 3 phase with 6 coils(2
coils in each phase) and 8 magnets what would you say the
wattage would it put out? i figure about 200 to 210 watts at 450
rpm.
#Post#: 5086--------------------------------------------------
Re: started a new stator
By: killer Date: January 9, 2015, 12:11 pm
---------------------------------------------------------
Probaly going to make ir a dual magnet plate one to drop the cut
in speed.
#Post#: 5088--------------------------------------------------
Re: started a new stator
By: killer Date: January 9, 2015, 1:19 pm
---------------------------------------------------------
Well i got 72 lbs pull each magnet. So i should be good then. On
a single plate turbine
#Post#: 5106--------------------------------------------------
Re: started a new stator
By: killer Date: January 11, 2015, 9:55 pm
---------------------------------------------------------
test coils as follows. single is 5 volt, two are 9.25 volts. So
9.25 x 1.732 = 16.021 volts in 3 phase? could be more cause
coils are not mounted down but im just learn too
#Post#: 5109--------------------------------------------------
Re: started a new stator
By: killer Date: January 12, 2015, 9:30 am
---------------------------------------------------------
Coil is the shape of picture , volts are ac for now.
#Post#: 5110--------------------------------------------------
Re: started a new stator
By: killer Date: January 12, 2015, 9:32 am
---------------------------------------------------------
Cant post picture from phone , but when i get home i will. But
the coils are the shape of the seagull 75 ones just out of 17
gauge
#Post#: 5113--------------------------------------------------
Re: started a new stator
By: killer Date: January 12, 2015, 12:04 pm
---------------------------------------------------------
Yes but they black epoxie coated
#Post#: 5114--------------------------------------------------
Re: started a new stator
By: killer Date: January 12, 2015, 12:29 pm
---------------------------------------------------------
The reason for 450 rpm is my tach broke and i know my drill
turns 450 rpm with a good charged battery.
#Post#: 5117--------------------------------------------------
Re: started a new stator
By: killer Date: January 12, 2015, 10:38 pm
---------------------------------------------------------
made a new coil. it put out 9 volts with fresh battery. its 1/2
inch thick. but picture was taken after i had been playing with
it.
#Post#: 5118--------------------------------------------------
Re: started a new stator
By: killer Date: January 12, 2015, 10:41 pm
---------------------------------------------------------
i think this new coil should work better
*****************************************************
DIR Next Page