DIR Return Create A Forum - Home
       ---------------------------------------------------------
       kycbradio
  HTML https://kycbradio.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: GRANT-XL
       *****************************************************
       #Post#: 82--------------------------------------------------
       Grant-XL (8719 PLL) 10 KC Jump Modification
   DIR By: kycbradio
       Date: October 5, 2018, 4:00 pm
       ---------------------------------------------------------
       Grant-XL (8719 PLL) 10 KC Jump Modification
       Basically, you need to either add voltage or ground pin #16 on
       the MB8719 PLL.
       Here's how to do a 10 Kc UP jump only:
       1. Cut trace to pin #16 on the PLL.
       2. Install a 4.7K resistor across the cut you made.
       3. Using a SPST switch, one side of the switch goes to the
       cut-side of pin #16
       4. The other side of the switch goes to pin #9 of the PLL. (8
       volts)
       When you apply the 8 volts, this pulls pin #16 high causing the
       10 kc jump up.
       This will not work on all channels.
       For a 10 Kc DOWN jump only:
       1. Ground pin #16 using a SPST switch. No cut to the PLL is
       necessary.
       Pulling pin 16 low will cause it to jump down 10Kc.
       This too will not work on all channels.
       For a 10 Kc UP and DOWN switch:
       Perform the trace cut/resistor addition described above.
       Use a SPDT switch and wire as follows:
       1. Center of switch goes to pin #9 of PLL (8 volts)
       2. One side of switch goes to the cut side of pin #16.
       3. The last side goes to pin #18 of PLL (or ground)
       This will allow you to jump 10Kc up or down.
       *****************************************************
       Page 1 of 1