gopher.createaforum.com/1/forums/kycbradio/p/60

   DIR Return Create A Forum - Home
       ---------------------------------------------------------
       kycbradio
  HTML https://kycbradio.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: Sears Roadtalker
       *****************************************************
       #Post#: 60--------------------------------------------------
       Sears Roadtalker Channel Expansion
   DIR By: kycbradio
       Date: October 5, 2018, 12:21 pm
       ---------------------------------------------------------
       Sears Roadtalker Channel Expansion
       1. Open the radio and you will find a metal case around the pll
       chip.unsolder this.
       2. Cut the trace around pin 9 and 8
       3. Solder a 4.7k resistor from pin 8 to ground.
       4. Install a 6 posistion/ double pole rotary swicth in the
       radio.
       Then run wires (the red lines) from the switch posistions to the
       locations on the pc board.
       5. Solder a 1n914 diode from pin 1 to pin 4 on the switch.
       6. Solder a wire from pins 2A to 3A to 4A to 5A.
       Adjust t302, the VCO, so that the radio will TX/RX on all the
       extra channels.
       HINT: USE A PLASTIC TUNING TOOL TO MAKE THIS ADJUSTMENT OR YOU
       WILL BREAK THE COIL!!
       POSITION  1
       Channel 1 to 40 is =  26.485 to 26.925
       POSITION  2
       All the regular CB channels
       POSITION  3
       Channel 12 to 27 is = 27.425 to 27.595
       POSITION  4
       Channel 1 to 40 is =  27.605 to 28.045
       POSITION 5 and 6 will give regular CB Channels
       *****************************************************
       Page 1 of 1