DIR Return Create A Forum - Home
       ---------------------------------------------------------
       kycbradio
  HTML https://kycbradio.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: President Grant
       *****************************************************
       #Post#: 58--------------------------------------------------
       President Grant Slider Modification
   DIR By: kycbradio
       Date: October 5, 2018, 12:04 pm
       ---------------------------------------------------------
       President Grant Slider Modification
       1.  Cut D-45.
       2.  Find D-79 and jump it (Solder a wire across it)
       3.  Remove r-120 and replace it with a 470 ohm resistor.
       4.  Find the BLUE wire from the clarifier knob and cut it just
       before it connects to the PCB. Solder it into the hole that is
       next to where R-120 is.
       5.  Find the GREY wire from the clarifier knob and cut it just
       before it connects to the PCB. Solder it to a constant 8.5 volt
       supply. (This can be the center pin of TR-39 )
       Hopefully this should give you about 3 khz of slide.
       *****************************************************
       Page 1 of 1