DIR Return Create A Forum - Home
---------------------------------------------------------
kycbradio
HTML https://kycbradio.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Emperor TS-5010
*****************************************************
#Post#: 56--------------------------------------------------
Emperor TS-5010 RIT Modification
DIR By: kycbradio
Date: October 5, 2018, 11:46 am
---------------------------------------------------------
Emperor TS-5010 RIT Modification
1. Remove top and bottom covers.
2. On the top of the main board find D140.Cut it.
3. Solder one end of a 10 OHM resistor to the location in the
picture below.
4. Take a 7.5v zener diode and solder the end without the band
to the small brass shield.
5. Now solder to other end of the diode to the open end of the
resistor.
6. Find the PC Board that is behind the RIT Knod
7. Cut the trace as you see in the picture above.
8. Solder a wire(See the green wire in the pics) from the point
that the diode and resistor meet togeteher to the bottom of the
board where you made the cut.
Aligning the RIT
1. Place the radio so that the smaller PC Board is facing up.
2. Turn it on and dial up 28.000 MHZ and put the rit dead
center.
3. On the samller PC Board locate J502.(upper right)
4. Pull the grey cable off the board and connect it to your
frequency counter.
(Sorry you can't use them $49 dollar specials from copper. You
have to have a frequency counter with a probe on it)
5. Hook up the probe and if it should read 38.695 +/- 100 Hz.
6. If not then adjust L501.
7. Put the radio back together.You shound have about 6KHz of
slide.
*****************************************************
Page 1 of 1