DIR Return Create A Forum - Home
       ---------------------------------------------------------
       kycbradio
  HTML https://kycbradio.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: Cobra 25 GTL/LTD/Classic
       *****************************************************
       #Post#: 22--------------------------------------------------
       Cobra 25 Modulator
   DIR By: kycbradio
       Date: October 5, 2018, 4:30 am
       ---------------------------------------------------------
       Cobra 25 Modulator
       PARTS NEEDED:
       1- 220uF (16 to 25 volt) electrolytic capacitor.
       1- 100 to 200 Ohm resistor. (1/4 to 1/2 watt)
       ASSEMBLY:
       1. Make sure your radio is peaked out.
       2. Unsolder JP6 near final.
       3. In JP6 holes, solder the 220uF capacitor. (negative side of
       cap. faces final)
       4. On the solder side of the board, solder the resistor across
       the 220uF capacitor.
       You can use different resistor values to get the desired
       dead-key.
       *****************************************************
       Page 1 of 1