DIR Return Create A Forum - Home
       ---------------------------------------------------------
       kycbradio
  HTML https://kycbradio.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: CB Radio Amplifiers 
       *****************************************************
       #Post#: 116--------------------------------------------------
       Texas Star DX 250HDV / DX 350HDV CW Transmitter To AMP
       Conversion
   DIR By: kycbradio
       Date: October 9, 2018, 1:55 pm
       ---------------------------------------------------------
       Texas Star DX 250HDV / DX 350HDV CW Transmitter To AMP
       Conversion
       1. Remove yellow 2200K cap of the oscillator board from the PCB
       2. Remove red wire of oscillator board from RF choke
       3. Remove green wire of oscillator board and attached 33pf cap
       4. Solder the leg of 15 or 18pf cap to input trace on PCB
       5. Remove black wire of oscillator board from keying jack
       6. Remove oscillator board
       7. Locate jumper wire attached to backside of red switch
       8. Unsolder the ground end of jumper wire closest to the relay
       9. Solder this end to open trace behind green switch
       10. Remove wire from outer lug of blue pot and solder to other
       outer lug
       11. Remove 10-ohm resistor piggy-backed to 15K resistor located
       next to the white sand block resistor and RF choke
       *****************************************************
       Page 1 of 1