DIR Return Create A Forum - Home
---------------------------------------------------------
evit3D
HTML https://evit3d.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Archive
*****************************************************
#Post#: 1253--------------------------------------------------
Original Character Project - 1st Year
By: LuisM Date: February 8, 2016, 1:58 pm
---------------------------------------------------------
These are the images of my original character (sorry if these
images are really big)
HTML http://orig03.deviantart.net/0d4d/f/2016/039/8/6/character_front_by_luism91-d9r0had.jpg
HTML http://orig00.deviantart.net/03f7/f/2016/039/a/d/character_side_by_luism91-d9r0hif.jpg
HTML http://orig03.deviantart.net/3a5b/f/2016/039/5/7/character_back_by_luism91-d9r0how.jpg
#Post#: 1256--------------------------------------------------
Re: Original Character Project - 1st Year
By: Ace Date: February 8, 2016, 2:00 pm
---------------------------------------------------------
It looks like there's a seam running through the center of the
character. You might consider sealing that seam with some water.
11/10 -IGN
#Post#: 1257--------------------------------------------------
Re: Original Character Project - 1st Year
By: HanayuZero Date: February 8, 2016, 2:03 pm
---------------------------------------------------------
There are a few place where you can see the seams, and the face
looks really blocky still. Other than that great job on the
jacket!
#Post#: 1260--------------------------------------------------
Re: Original Character Project - 1st Year
By: Elijah Faison Date: February 8, 2016, 2:07 pm
---------------------------------------------------------
I like your character, it's looking good so far. What I had
noticed that there was a line going through your character
starting at the head and goes down towards the bottom. So your
character basically was in two. Maybe you may not have time to
fix it, but just in case, what you can do to fix that is have
both sides selected and go to mesh and click 'combine'. Then go
to the vertex component, select the whole character (all
vertices selected), Edit mesh, then merge. That should fix the
line problem.
*****************************************************