DIR Return Create A Forum - Home
---------------------------------------------------------
CycleKarts GB
HTML https://cyclekartsgb.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Tech Forum
*****************************************************
#Post#: 6654--------------------------------------------------
Re: grinding away some metal on the torque converter plate - yea
or nay?
By: Tinworm Date: May 4, 2022, 11:03 am
---------------------------------------------------------
oh yes, I see
here you can see what I mean about the line of my driving cog
and the exhaust[img][/img]
Mind you, I have not actually traced the line of the chain yet,
so my exhaust may just go straight through between the top and
bottom (out and return).
#Post#: 6669--------------------------------------------------
Re: grinding away some metal on the torque converter plate - yea
or nay?
By: Adrian Date: May 4, 2022, 2:52 pm
---------------------------------------------------------
I had to grind off a lot of the stiffening ribs on the TC. I was
concerned about doing it but its still as straight as a die.
:>)
#Post#: 6671--------------------------------------------------
Re: grinding away some metal on the torque converter plate - yea
or nay?
By: Tinworm Date: May 4, 2022, 4:14 pm
---------------------------------------------------------
[quote author=Adrian link=topic=867.msg6669#msg6669
date=1651693925]
I had to grind off a lot of the stiffening ribs on the TC. I was
concerned about doing it but its still as straight as a die.
:>)
[/quote]
Coming from you, Adrian, that is very encouraging. Cheers
#Post#: 6798--------------------------------------------------
Re: grinding away some metal on the torque converter plate - yea
or nay?
By: Adrian Date: May 13, 2022, 4:19 am
---------------------------------------------------------
I have seen aluminium plate used for the job too and it worked
fine. f
#Post#: 7093--------------------------------------------------
Re: grinding away some metal on the torque converter plate - yea
or nay?
By: Clive H Date: June 17, 2022, 3:07 pm
---------------------------------------------------------
I had the same problem and I machined them down to fit. I would
just grind off enough to make it fit.
*****************************************************
DIR Previous Page
DIR Next Page