DIR Return Create A Forum - Home
       ---------------------------------------------------------
       CycleKarts GB
  HTML https://cyclekartsgb.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: Tech Forum
       *****************************************************
       #Post#: 14892--------------------------------------------------
       Easy governor removal
   DIR By: NewbieNick
       Date: April 28, 2026, 5:06 am
       ---------------------------------------------------------
       Easy governor removal. For new builders. Remove existing
       governor,  remove crankcase cover, remove recoil starter &
       flywheel. Pin punch the operating pin on top of engine, be sure
       to get the washer . Pin punch pin behind flywheel to remove
       nylon gear. Blank of both holes.
       Job done no swearing or tears.
       Happy building
       #Post#: 15186--------------------------------------------------
       Re: Easy governor removal
   DIR By: Nick _Mantis
       Date: June 29, 2026, 3:04 am
       ---------------------------------------------------------
       As an additional note.
       Instead of blanking off the hole for the governor, the crankcase
       pressure is sufficient to run a pulse pump.
       You can use a fitting mounted through the governor hole to run
       it if you do not want to use the standard top tank all these
       engines come with.
       It allows you to fit the tank wherever you want and reduce the
       height of your engine installation.
       Pumps and fittings available through a lot of kart shops (sold
       for Honda Prokart's and cadets).
       *****************************************************
       Page 1 of 1