DIR Return Create A Forum - Home
---------------------------------------------------------
Chainsaw Repair
HTML https://chainsawrepair.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Husqvarna
*****************************************************
#Post#: 5922--------------------------------------------------
Husqvarna 272 hard to start
DIR By: huskyman
Date: December 25, 2011, 11:43 pm
---------------------------------------------------------
Hello everyone, I have a freshly rebuilt Husky 272xp with a new
barrel and piston, carb kit. I am having a hard time starting it
but once it is started it runs great. The fuel line and filter
looks good. The spark arrestor is clean and it has a new plug.
Any suggestions as to the hard starting?
#Post#: 5924--------------------------------------------------
Re: Husqvarna 272 hard to start
DIR By: farmboy
Date: December 26, 2011, 6:21 am
---------------------------------------------------------
Check needle height in carb. Low needle = hard start. Just one
thing there are more drawing a blank for others right now.
Shep
#Post#: 5927--------------------------------------------------
Re: Husqvarna 272 hard to start
DIR By: man of stihl
Date: December 26, 2011, 7:08 am
---------------------------------------------------------
Also richen low screw a little.
#Post#: 5930--------------------------------------------------
Re: Husqvarna 272 hard to start
DIR By: jhutton
Date: December 26, 2011, 7:59 am
---------------------------------------------------------
As a rule of thumb set low high needles to 1 to1.5 out. When you
say hard to start isnt the 272 the saw that has two gaskets plus
intake block w/ rubber that has to be mounder to cyl then set to
base. From you post the carb not letting fuel in with choke out
or is it over fueling?Just tring to help. JOdy
#Post#: 5931--------------------------------------------------
Re: Husqvarna 272 hard to start
DIR By: man of stihl
Date: December 26, 2011, 8:01 am
---------------------------------------------------------
--- Quote from: jhutton link ---
>
> As a rule of thumb set low high needles to 1 to1.5 out. When
you say hard to start isnt the 272 the saw that has two gaskets
plus intake block w/ rubber that has to be mounder to cyl then
set to base. From you post the carb not letting fuel in with
choke out or is it over fueling?Just tring to help. JOdy
>
--- End Quote ---
Good point. I was assuming he was not geting enough fuel.
#Post#: 5997--------------------------------------------------
Re: Husqvarna 272 hard to start
DIR By: huskyman
Date: December 27, 2011, 12:49 pm
---------------------------------------------------------
Thanks guys I will check my adjustments. The needle is set up
perfect and the low is out 1 1/4 turns I will take it out
another 1/4 turn. Thanks again!
*****************************************************
Page 1 of 1