DIR Return Create A Forum - Home
       ---------------------------------------------------------
       Chainsaw Repair
  HTML https://chainsawrepair.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: Chainsaws not listed - Gas OPE
       *****************************************************
       #Post#: 72989--------------------------------------------------
       Baumr-AG 92 Chainsaw cover modification
       By: aleksgavri Date: August 5, 2016, 3:47 am
       ---------------------------------------------------------
       Hey,
       I've just purchased a Baumr-AG 92cc and for a Chinese saw I can
       say that I am very happy. She's a little on the thirsty side
       however for someone who cuts 7-10 tonne of wood a year it
       certainly does the job. The link below will show you a MAJOR
       fault in the design system. The air filter is in the worst
       possible location and I wanted to know if anyone had any success
       in doing something similar? What has happened to others in the
       past is that the air intake is covered by a very cheap Chinese
       filter and eventually saw dust gets sucked up into the
       carburetor and into the crankcase (you can imagine it does
       wonders in there). So ideally easy access will mean that I can
       easily clean it without procrastination creeping in. What I
       wanted to do was cut the plastic cover and create a hinged door,
       any help is greatly appreciated!
  HTML https://www.youtube.com/watch?v=kY2GYT5SOGs
       - approx 2min 30sec
       into the video.
  HTML https://www.youtube.com/watch?v=kcNJDflngtU
       - what can
       potentially happen.
       #Post#: 72995--------------------------------------------------
       Re: Baumr-AG 92 Chainsaw cover modification
       By: Chris-PA Date: August 5, 2016, 1:03 pm
       ---------------------------------------------------------
       Strange saw, with reeds even.  From other pictures it looks to
       have 1/2 of an A/V system.
       As for the filter, on one hand there is a lot of stuff trapped
       on the filter, so you could almost say it was doing its job.
       Perhaps with a bit of flashing clean up and some sealant between
       the halves (like I've done on other Chinese saw filters), and
       maybe some gasketing to the carb.  But not being able to get to
       it is a major issue, especially since it seems to have no
       effective pre-filtration system.
       #Post#: 73231--------------------------------------------------
       Re: Baumr-AG 92 Chainsaw cover modification
       By: sharkey Date: August 28, 2016, 7:02 am
       ---------------------------------------------------------
       Anyone know what model copy this saw is of?
       *****************************************************