DIR Return Create A Forum - Home
---------------------------------------------------------
Chainsaw Repair
HTML https://chainsawrepair.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Chain - Bars - Grinders - Filing
*****************************************************
#Post#: 63861--------------------------------------------------
short hard nose bars
DIR By: dannyupsolate
Date: October 25, 2015, 7:26 pm
---------------------------------------------------------
been junking some small poulan factory bars today eat up tips.
found some short hardnose bars 14 and 16 inch any disadvantage
to using them on wildthing class saws.
#Post#: 63862--------------------------------------------------
Re: short hard nose bars
DIR By: Chainsawrepair
Date: October 25, 2015, 7:30 pm
---------------------------------------------------------
Had a bunch of them too. I dont know where they have went but no
biggie.
Usually the banana nose style.
#Post#: 63872--------------------------------------------------
Re: short hard nose bars
DIR By: dannyupsolate
Date: October 25, 2015, 9:00 pm
---------------------------------------------------------
have any of you used hard nose bars on these small saws and how
well did it work out.
#Post#: 63878--------------------------------------------------
Re: short hard nose bars
DIR By: Chainsawrepair
Date: October 26, 2015, 10:13 am
---------------------------------------------------------
They came on the small saws 10" 12" etc and up. I used them a on
them and they were fine.
#Post#: 63879--------------------------------------------------
Re: short hard nose bars
DIR By: Chainsawrepair
Date: October 26, 2015, 10:16 am
---------------------------------------------------------
Front little poulan XX came with one.
HTML http://i59.photobucket.com/albums/g289/doemaster789/XXand2000.jpg
#Post#: 63884--------------------------------------------------
Re: short hard nose bars
DIR By: dannyupsolate
Date: October 26, 2015, 12:06 pm
---------------------------------------------------------
so if customer questions the hard nose bar just tell them they
will love it.
#Post#: 63885--------------------------------------------------
Re: short hard nose bars
DIR By: Chainsawrepair
Date: October 26, 2015, 12:34 pm
---------------------------------------------------------
Just make sure they run the chain alittle looser. Dont tighten
it up so tight like they do.
Good for trenching and root cutting too. ;D
#Post#: 63893--------------------------------------------------
Re: short hard nose bars
DIR By: dannyupsolate
Date: October 26, 2015, 3:51 pm
---------------------------------------------------------
thanks I have never used one. they look like they might be
tougher than these new oem bars
#Post#: 63905--------------------------------------------------
Re: short hard nose bars
DIR By: Al Smith
Date: October 26, 2015, 7:25 pm
---------------------------------------------------------
I have the same 14" hard nose bar on a Poulan s-25 that was on
it when I bought the saw new .Now I know I've went through at
least 25 chains on that thing since the mid 70's .Bar is still
fine but I've dressed it on a belt sander several times in all
those years .
Saw is fine too .I ran that thing over 30 years before I had to
rebuild the carb.
#Post#: 63907--------------------------------------------------
Re: short hard nose bars
DIR By: dannyupsolate
Date: October 26, 2015, 7:31 pm
---------------------------------------------------------
much tougher than newer roller tips then just pitched 4 in scrap
pile all dished out right behind roller. oem bars
*****************************************************
Page 1 of 1