DIR Return Create A Forum - Home
---------------------------------------------------------
Chainsaw Repair
HTML https://chainsawrepair.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Stihl
*****************************************************
#Post#: 62787--------------------------------------------------
Ran some 044's today
DIR By: aclarke
Date: October 4, 2015, 10:55 pm
---------------------------------------------------------
Got together with Mike (gatekeeper) at a friends ranch today and
played with a few ported 044's and shot some squirrels!! Fun
day!
Had troubled uploading iPhone to pc so Mikes gonna post the vid
links
#Post#: 62788--------------------------------------------------
Re: Ran some 044's today
DIR By: Gatekeeper
Date: October 4, 2015, 10:59 pm
---------------------------------------------------------
First one stock 440
HTML https://youtu.be/dwk-Ze84rTI
#Post#: 62789--------------------------------------------------
Re: Ran some 044's today
DIR By: Gatekeeper
Date: October 4, 2015, 11:00 pm
---------------------------------------------------------
044
HTML https://youtu.be/kPVx-SDteY0
#Post#: 62790--------------------------------------------------
Re: Ran some 044's today
DIR By: Gatekeeper
Date: October 4, 2015, 11:06 pm
---------------------------------------------------------
2nd 044
HTML https://youtu.be/tEG9SFBXhw4
#Post#: 62792--------------------------------------------------
Re: Ran some 044's today
DIR By: aclarke
Date: October 4, 2015, 11:23 pm
---------------------------------------------------------
Woods dry/ hard willow. Same bar chain all saws. First Modded
saw is an original small pin 044. Intake, exhaust and transfer
work, cylinder wasn't machined on either mod saws.
Second modded saw has a newer ms440 case (slightly more case
volume than early case) with NOS small pin crank and early
cylinder with less exhaust and transfer duration, intake is
about 160 on both.
#Post#: 62793--------------------------------------------------
Re: Ran some 044's today
DIR By: Gatekeeper
Date: October 4, 2015, 11:34 pm
---------------------------------------------------------
Both were way better than stock. I liked the one without the
stack best
#Post#: 62794--------------------------------------------------
Re: Ran some 044's today
DIR By: aclarke
Date: October 5, 2015, 12:00 am
---------------------------------------------------------
Yep, I think it would pull a 28"+ better.
What's the deal with the early jug on a 12mm piston? Pin
location bad?
#Post#: 62795--------------------------------------------------
Re: Ran some 044's today
DIR By: Gatekeeper
Date: October 5, 2015, 12:02 am
---------------------------------------------------------
Yes. Have to really look at ring ends. Still have never tried a
268 or 372 piston in one to get one center ring.
#Post#: 62796--------------------------------------------------
Re: Ran some 044's today
DIR By: adam32
Date: October 5, 2015, 8:26 am
---------------------------------------------------------
The one with the stack was pulling more RPM in wood eh? The 3rd
one cleaned up in the cut nice but I bet it could go a bit
higher in wood...
#Post#: 62797--------------------------------------------------
Re: Ran some 044's today
DIR By: treeslayer2003
Date: October 5, 2015, 8:46 am
---------------------------------------------------------
--- Quote from: aclarke link ---
>
> Yep, I think it would pull a 28"+ better.
>
> What's the deal with the early jug on a 12mm piston? Pin
location bad?
>
--- End Quote ---
uh oh, i gonna have to tear this one back apart to check? this
is not a KS, its a mahle 10mm with a 12mm meteor..............
*****************************************************
Page 1 of 2
DIR Next Page