DIR Return Create A Forum - Home
       ---------------------------------------------------------
       Chainsaw Repair
  HTML https://chainsawrepair.createaforum.com
       ---------------------------------------------------------
       *****************************************************
   DIR Return to: McCulloch
       *****************************************************
       #Post#: 61487--------------------------------------------------
       mcc 1435 was running, now wont start
       By: jrdplowing Date: September 12, 2015, 7:35 pm
       ---------------------------------------------------------
       has spark, and has 75lbs comp with 1 full pull, missing primer
       bulb but was running fine until i filled the tank with gas, and
       new spark plug .030 gap. also wet air filter with gas directly
       and wont even pop,tried with and without choke,any help would be
       appreciated
       #Post#: 61491--------------------------------------------------
       Re: mcc 1435 was running, now wont start
       By: Chainsawrepair Date: September 12, 2015, 8:18 pm
       ---------------------------------------------------------
       Try .020 and pull plug pull over and let set 24 hours to air dry
       from guessing flooding.  Also check for spark and make sure
       turned to on. Yes it happens even to me.
       Need more then 75lbs so keep pulling till psi stops going up and
       then look.
       #Post#: 61492--------------------------------------------------
       Re: mcc 1435 was running, now wont start
       By: jrdplowing Date: September 12, 2015, 8:44 pm
       ---------------------------------------------------------
       yes sounds good, i will try and get back on a repost,probably by
       monday, thanks
       *****************************************************