DIR Return Create A Forum - Home
---------------------------------------------------------
Chainsaw Repair
HTML https://chainsawrepair.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Chainsaws not listed - Gas OPE
*****************************************************
#Post#: 57716--------------------------------------------------
Remington Rodeo Pro (RM5520R) 20 inch
By: JCortez3 Date: May 5, 2015, 11:13 pm
---------------------------------------------------------
I currently have a fairly new Remington 20 inch 55cc chainsaw I
bought at a swap meet which i learned my lesson but the problem
the guy said was it ran but was missing the muffler so I bought
it dirt cheap and ordered a original muffler and gasket and
installed it changed the gas to new gas bought new plug and
cannot get it running it is getting great spark I could not get
it to fire up so I just tried to focus on even getting it to
kick back a bit but nothing not starting fluid not gas in plug
hole nothing choke on choke off full throttle half throttle no
throttle I am not sure if its getting gas I'm just focusing on
getting it to make a little noise first much less run good the
one thing I narrowed it down to was compression was not up there
but could that keep it from even making a noise that it wants to
start?
#Post#: 57717--------------------------------------------------
Re: Remington Rodeo Pro (RM5520R) 20 inch
By: jmester Date: May 6, 2015, 5:01 am
---------------------------------------------------------
Did you look at the piston and cylinder when you had the muffler
off. Not real sure how your model is setup could be a torn
intake boot, leaking gasket on the intake block. I would also
stay away from starting fluid. Use a little mix down through the
carb. Is the plug wet after you spray it.
#Post#: 57720--------------------------------------------------
Re: Remington Rodeo Pro (RM5520R) 20 inch
By: Chainsawrepair Date: May 6, 2015, 11:45 am
---------------------------------------------------------
Check plug to see if wet or dry. If dry put mix in a squirt
bottle and spray though carb while holding throttle open. Then
try to start.
I am thinking this is that China made saw that has many names in
55cc. Craftsman, Troy-Bilt etc.
Manuals can be found here I think.
HTML http://www.mtdparts.com/equipment/mtdparts/remington-rm5520r-20-gas-chain-saw-rm5520r
*****************************************************