DIR Return Create A Forum - Home
---------------------------------------------------------
Chainsaw Repair
HTML https://chainsawrepair.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Homelite
*****************************************************
#Post#: 56710--------------------------------------------------
C-72 not cutting properly
By: jrdplowing Date: April 9, 2015, 12:04 pm
---------------------------------------------------------
i have a newer chain on my C-72,has only been sharpened about 4,
5 times, but after my last sharpen it performed very poorly on
some downed pople and would not cut straight and kept wanting to
bind,was so bad i pulled out my homelite 240 and on the same
tree it just blew the 72 away,any help on this, thanks
#Post#: 56711--------------------------------------------------
Re: C-72 not cutting properly
By: 660magnum Date: April 9, 2015, 12:17 pm
---------------------------------------------------------
If the chain rakers have not been lowered to be .025" below the
height of the cutters, your chain cutters will be held away from
the wood by the rakers. The chain will not cut.
#Post#: 57177--------------------------------------------------
Re: C-72 not cutting properly
By: jrdplowing Date: April 21, 2015, 9:16 pm
---------------------------------------------------------
thanks magnum, that is what i will check now and see if it works
better,let you know,thanks
#Post#: 57287--------------------------------------------------
Re: C-72 not cutting properly
By: jrdplowing Date: April 24, 2015, 1:12 pm
---------------------------------------------------------
i had to cut the rakers down to .025-.030, and the bar had a bad
ridge on both sides so i filled that down and it got a little
better but still wants to go crooked, i dont know why but it
lost its chain tension right away,so iam going to retension and
try it again,thanks
#Post#: 57289--------------------------------------------------
Re: C-72 not cutting properly
By: 660magnum Date: April 24, 2015, 1:26 pm
---------------------------------------------------------
If your cutters are different from one side to the other, the
more aggressive cutting side will do more cutting and cause the
cut to go crooked
#Post#: 57301--------------------------------------------------
Re: C-72 not cutting properly
By: jrdplowing Date: April 24, 2015, 6:12 pm
---------------------------------------------------------
found there is alot of play in the bar to chain driver
clearence, probably going to need a new bar,this one is over 30
yrs of use,looking for a new one,thanks, let you know if it
straightens out
*****************************************************