DIR Return Create A Forum - Home
---------------------------------------------------------
Chainsaw Repair
HTML https://chainsawrepair.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Tool Shed
*****************************************************
#Post#: 45470--------------------------------------------------
Oversized bar stud made for a stripped case.
By: echo nut Date: August 28, 2014, 6:43 pm
---------------------------------------------------------
Made this a few days ago for my buddies 041 which he found in a
dumpster because the case was stripped. He asked if i could help
him out. 1/2 hour later it was good as new. Turned a stud 3/8"
to match the new tapped hole in the case...Bob
#Post#: 45474--------------------------------------------------
Re: Oversized bar stud made for a stripped case.
By: 660magnum Date: August 28, 2014, 8:33 pm
---------------------------------------------------------
+1
#Post#: 45483--------------------------------------------------
Re: Oversized bar stud made for a stripped case.
By: srcarr52 Date: August 29, 2014, 9:08 am
---------------------------------------------------------
Did you single point thread it or use a die?
#Post#: 45488--------------------------------------------------
Re: Oversized bar stud made for a stripped case.
By: Chainsawrepair Date: August 29, 2014, 11:11 am
---------------------------------------------------------
Hey Bob. Nice to see you around.
Bob is one of those specialized welding types too. Top
notch............ ;) 8)
#Post#: 45489--------------------------------------------------
Re: Oversized bar stud made for a stripped case.
By: Al Smith Date: August 29, 2014, 11:17 am
---------------------------------------------------------
It would be relatively easy to do if you had a lathe and the
knowledge to run the thing .Nice job .
If you had a lathe that would cut both SAE and metric even more
easy .FWIW A Stihl 056 has a stud with 10mm on the saw side and
8 mm on the bar side which makes another option for repair .
#Post#: 45776--------------------------------------------------
Re: Oversized bar stud made for a stripped case.
By: 3000 FPS Date: September 3, 2014, 10:53 pm
---------------------------------------------------------
Nice job. It always a pleasure to see good work.
*****************************************************