DIR Return Create A Forum - Home
---------------------------------------------------------
Chainsaw Repair
HTML https://chainsawrepair.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Poulan
*****************************************************
#Post#: 94--------------------------------------------------
Poulan 505
DIR By: man of stihl
Date: February 26, 2011, 6:35 am
---------------------------------------------------------
s\My Pictures\saw pics\saw pics 024.jpg [left]my pp 505
project[/left]
#Post#: 95--------------------------------------------------
Re: poulan projects
DIR By: man of stihl
Date: February 26, 2011, 6:37 am
---------------------------------------------------------
C:\Documents and Settings\Owner\My Documents\My Pictures\saw
pics\saw pics 025
#Post#: 170--------------------------------------------------
Re: poulan projects
DIR By: man of stihl
Date: February 26, 2011, 5:29 pm
---------------------------------------------------------
y Pictures\stuff\stuff 278.jpg[left]before muriatic acid[/left]
#Post#: 173--------------------------------------------------
Re: poulan projects
DIR By: man of stihl
Date: February 26, 2011, 5:30 pm
---------------------------------------------------------
My Pictures\stuff\stuff 279.jpg[left]after muriatic acid
:)[/left]
#Post#: 178--------------------------------------------------
Re: poulan projects
DIR By: Cut4fun
Date: February 26, 2011, 5:41 pm
---------------------------------------------------------
Did you measure the bore? Is it the 505 82cc and did you find
the right ring for replacement.
#Post#: 182--------------------------------------------------
Re: poulan projects
DIR By: man of stihl
Date: February 26, 2011, 6:01 pm
---------------------------------------------------------
the bore measured 54mm and the ring should be in monday or
tuesday. 8) the 475 is 52mm.correct?
#Post#: 186--------------------------------------------------
Re: poulan projects
DIR By: man of stihl
Date: February 26, 2011, 6:23 pm
---------------------------------------------------------
My Pictures\saw pics\stuff.jpg[left]the piston cleaned up well
also. i dont have a before pic :-[[/left]
#Post#: 314--------------------------------------------------
Re: Poulan 505 projects
DIR By: man of stihl
Date: February 28, 2011, 5:42 pm
---------------------------------------------------------
i did a light port job on the cylinder tonight. both ports
seemed real wide. about 2mm from piston witness lines so i left
the sides alone. raised the roof in the exhaust a little.
lowered the intake a little.cleaned out casting flaws in piston
windows. replaced gasket with threebond 1194. put the cylinder
back on. did a compression test got 150 psi. ;D ;D ;D. i'll
finish tomorrow i hope.
#Post#: 320--------------------------------------------------
Re: Poulan 505 projects
DIR By: Gatekeeper
Date: February 28, 2011, 6:35 pm
---------------------------------------------------------
Do you have the rev-limited green coil in it?
#Post#: 323--------------------------------------------------
Re: Poulan 505 projects
DIR By: man of stihl
Date: February 28, 2011, 7:39 pm
---------------------------------------------------------
--- Quote from: Gatekeeper link ---
>
> Do you have the rev-limited green coil in it?
>
--- End Quote ---
well the coil is green! :'( finished putting it together. i
couldn't stand it. i had to see how it runs. seems to run good.
nice throttle response. idles ok too. ;D
*****************************************************
Page 1 of 42
DIR Next Page