DIR Return Create A Forum - Home
---------------------------------------------------------
690 Enduro R
HTML https://690enduro.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: General Maintenance
*****************************************************
#Post#: 3888--------------------------------------------------
clutch plates grabbing?
By: renpar Date: April 14, 2018, 3:37 am
---------------------------------------------------------
Hi guys, i recently burnt out my clutch on an over night camping
trip and was able to just make it to the nearest town to get a
bus home. I retreived my bike a few days later and put a new
clutch plates in and it's going great. very responsive and feels
like a new bike. My only problem is that when i have the bike on
a stand and put it in gear, the wheel spins as fast as it does
with the clutch engaged. If i pull the clutch and lean on the
bike to put the rear wheel on the ground it will stop spinning,
but only just. As soon as i raise the wheel it begins spinning
just as fast. It did this before i burnt the clutch out but no
where nearly as much. Also, it a little harder to get it to
neutral when i stoped at the lights
there's also a tapping noise i can hear when the clutch is
engaged (lever not pulled). it seems to go away when i pull the
lever.
It's a 2010 model with 10k km
is this caused by
1. the clutch rod not pushing enough?
2. the clutch plates are brand new and gripping a lot because i
haven't been for good offroad ride yet?
3. i've done something wrong with the install?
cheers, Rene
#Post#: 3890--------------------------------------------------
Re: clutch plates grabbing?
By: Yodasaki Date: April 20, 2018, 12:28 am
---------------------------------------------------------
The information is very interesting.
*****************************************************