DIR Return Create A Forum - Home
---------------------------------------------------------
690 Enduro R
HTML https://690enduro.createaforum.com
---------------------------------------------------------
*****************************************************
DIR Return to: Tires
*****************************************************
#Post#: 1465--------------------------------------------------
Tusk and Motion Pro valve stem pullers
By: coarsegoldkid Date: July 31, 2014, 12:10 pm
---------------------------------------------------------
Rusty this might belong in a tool category that I didn't locate.
A valve stem puller is designed to be a dual purpose tool or so
I thought. My departed Motion Pro tool worked fine for me for a
short while. It removes the core and pulls the valve stem
through the rim. The Tusk Valve Stem Puller is a single purpose
tool. The end that is used to remove the core, at least on the
one that I bought, is not wide or deep enough to remove the
core. Once the core is removed it will screw into the valve stem
however. Make sure you include a proper core removing tool in
your kit just incase you need to mess with a tube. I now have
one in the form of a valve cap.
Bye the way the Motion Pro tool had a longer cable than the Tusk
which is a good thing. The downside was it was designed as a
two piece head and always unscrewed itself due to vibration
causing that small piece to get lost in the tool bag. Also the
cable on the Motion Pro frayed, painfully drew blood, and was
thrown away. Why is it so difficult to manufacture a simple
tool perform the intended task and last for more than a few
months?
#Post#: 2762--------------------------------------------------
Re: Tusk and Motion Pro valve stem pullers
By: Berlinnoi Date: April 28, 2015, 2:45 am
---------------------------------------------------------
It is the information that I was looking at the ground fit.
*****************************************************